Any home handyman knows the value of a workbench.This one provides plenty of work space, a large shelf, and a perforated peg-board backing for hanging tools. The tabletop is made of 3/4″ wafer board covered with 1/4″hard-board.The workbench shown here is 8′long, but you can make it any length to fit your work space. Cut [...]

If you enjoy our post, feel free to subscribes to our rss feeds

After the material has been dimensioned,lay out,joint and glue the stock for the top. Construct the leg assemblies next. After laying out the feet but before profiling them on the band saw, cut the 2″-deep mortises that will receive the leg tenons. This can be done on the drill press, clamping the work to a [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Step by Step Nesting Table Blueprint Make a Slab Start the tables by ripping three sheets of plywood in half to just under 24″ in width.You won’t need all that width,but it will come in handy later.As for the lengths, using the full 96″is a little wasteful,but it makes gluing the two halves together easier. [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Here’s a toy that’s sure to fascinate children:a duck that waddles across tabletops. It’s powered by a 5/8″ steel hex nut that acts as a drive weight. Just hang the hex nut over the edge of a table and give the duck a nudge sideways; it will rock from side to side and walk toward [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Here is a basic table design that can accommodate many uses. The table shown in the photo was made of redwood and assembled using waterproof glue and galvanized fasteners.Because it was designed to serve as a deck table,it is somewhat low in height. However,you can easily substitute other woods,use standard glue and fasteners,and raise the [...]

If you enjoy our post, feel free to subscribes to our rss feeds

You’ll always have a place to hang your hat with this easy-to-build hall tree. And by replacing the brass hooks with pot clips, you can turn it into a plant pole that is perfect for hanging vines.Either way,it’s a useful addition to any home. Begin by cutting all pieces to the listed dimensions. Arrange the [...]

If you enjoy our post, feel free to subscribes to our rss feeds

TV Cabinet Builder’s Tip: When building quality furniture, remember all wood grains should “run” in a certain direction. For this project: sides and back-vertical; top and bottom-left to right. After checking direction of wood grain,rough cut all members(slightly over sized).Note:The easiest way to work a large sheet of plywood initially is by placing it on [...]

If you enjoy our post, feel free to subscribes to our rss feeds