Made entirely from 2-by-4 and 1-by-3 stock, the extension table shown above can be attached to the outfeed or infeed ends of a radial arm saw table. Using 2-by-4s, cut the legs, rails, and stretchers to suit the dimensions of your saw, making the length of the legs equal to the distance between the top [...]

If you enjoy our post, feel free to subscribes to our rss feeds

The all-purpose table shown below is built with a combination of lumber and plywood. Refer to the dimensions in the illustration for a work surface that is 5 feet long, 3 feet wide, and 3 feet high. Saw the legs to length from 4-by4 stock, then prepare them for the rails: Cut a two-shouldered tenon [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Using commercial sawhorse brackets A pair of metal sawhorse brackets can help you transform a couple of 2-by-4s and 1-by-3s into a sturdy sawhorse, like the one shown at right. Saw the legs and crosspiece from 2-by-4s, then cut a bevel at the bottom of the legs so they will sit flat on the floor. [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Designed to accommodate both boards and plywood panels, the rack shown rests on the shop floor and attaches to joists in the ceiling. Lumber is loaded onto the rails from the end, while plywood can be stacked in the trough at the front and held in place by the hinged bar. Refer to the cutting [...]

If you enjoy our post, feel free to subscribes to our rss feeds

An auxiliary band saw table will significantly increase the machine’s versatility. The extension table shown above is especially handy for cutting long or wide pieces. Using 3/4 inch plywood, cut the top of the jig to a suitable diameter. Cut out the center and the edge to fit the top around the saw table and [...]

If you enjoy our post, feel free to subscribes to our rss feeds

Setting up a temporary roller stand With only a sawhorse, two C clamps, and a commercial roller, you can make a simple roller stand like the one shown at left. Make a T-shaped mast for the roller that is long enough to hold it at a suitable height. Screw the roller to the horizontal part [...]

If you enjoy our post, feel free to subscribes to our rss feeds